Detailed Directions for Use:

	CUT THE HEEL PROTECTOR TO SIZE – Select the diameter of the heel protector for your treasured shoe – it will shrink up to 50% during fitting so allow space between the heel and the protector for shrinkage to occur.
	Using sharp scissors cut the protector to the desired length, depending on how much protections you need. Average is 1.5 to 3cm per heel.
	PLACE HEEL IN THE PROTECTOR – Holding your shoe on it’s side, slip the protector over the heel and position it over the area you want to keep damage free.
	APPLY HEAT TO PROTECTOR TO SHRINK – With your hair dryer on high heat, aim the jet at the protector, slowly moving around the heel to heat all sides until it shrinks completely to fit your heel! The longer you heat the protector the more snug the fit. We recommend 30-60seconds for most hair dryers.
	SHRINKS TO EXACT HEEL SIZE IN SECONDS – Once it has shrunk, it will stay in place until you remove it. Do not try to adjust the positioning of the protector when it has been applied, unless you are removing it.

To Remove & Replace:

Using small sharp scissors, cut a small slit at the top or bottom of the protector (make sure you do not cut your heel!). Carefully separate the protector with your fingers by pulling it apart. Then replace with a new Heel Hugger to keep your shoes looking fabulous!